Clutch Disc 7-7\8" Dia.:Festy Spline?

[Biff]

Getting ready to install B6 DOHC into festy, Looking at the Miata Flywheel and pressure plate I have sitting on the floor an wondering if you could get a clutch with the larger diameter of seven and seven eights inches diameter but with the Festy spline size?
Anyone tried this?

[FB71]

yeah, Suzuki Swift GT, already been done

[jr.fester]

just have to redrill the festiva flywheel to hold the swift gt clutch and pressure plate.

[canadianfestiva]

Who here has installed the suzuki clutch on thier car? What has to be done? I found a could performance clutches and want to know how I would go about putting them on...

Does that only work for the DOHC B6? or can it be done for the SOHC as well...

[Biff]

FB71 , Tks , I will go to the parts store to get one, that makes it all to easy ,
Looking forward to the Miata B6 DOHC Spinning up to 7200 RPM !!!!
Look out !!!

[FB71]

you'll need to have the flywheel flat-milled and ground, and drilled to accept the Swift pressure plate. You'll also need to clearance the bell housing of the trans and the starter nose, as they'll interfere with the larger pressure plate.

[Biff]

FB71, I have the Miata pressure plate that bolts to the Miata Flywheel. All I should need is the Friction disc between the two, right?

[FB71]

no clue on that one. I don't think the Miata flywheel is the correct diameter (too large for the Festiva bell housing).

[Biff]

I will check that out?

[Biff]

Correct , Miata flywheel diameter is too large for festy bellhousing...

[Nerd Racing]

You should be fine using the stock clutch, people have run BP's for quite some time under normal driving conditions on a stock clutch.

[Fastiva604]

you guys.

Clutchnet.com

they make a festiva clutch. NO MODIFICATION REQUIRED!

YOU WILL SAVE MONEY AND TIME.

get the dual diaphram pressure plate and an organic street disk you wont be disappointed, i ran that on my first b6t swap wityh reich ecu and 16 psi, it gripped perfectly

[elcamino1]

you guys.

Clutchnet.com

they make a festiva clutch. NO MODIFICATION REQUIRED!

YOU WILL SAVE MONEY AND TIME.

get the dual diaphram pressure plate and an organic street disk you wont be disappointed, i ran that on my first b6t swap wityh reich ecu and 16 psi, it gripped perfectly

Can I sit in traffic without getting leg cramps?

[nonamekid]

Can I sit in traffic without getting leg cramps?

Yes, go to the gym and work on your leg muscles. Always seemed to work for me whenever I got a stiffer pressure plate....

[anomoly40]

I always wondered why my left pant leg fit tighter than my right. Now I know why.