headers

[bravekozak]

I wonder if these Genie extractors would fit?
The seller did not respond to my request for some center to center measurements across the bolt holes. They might be close, but I would have to buy an exhaust gasket to find out if the E5 exhaust is similar to the B6.

http://cgi.ebay.com.au/Ford-Laser-S-KA-KB-Extractors-Exhaust-Headrers_W0QQitemZ370180700785QQcmdZViewItemQQptZAU_Car_Parts_Accessories?hash=item370180700785&_trksid=p3286.c0.m14&_trkparms=66%3A2%7C65%3A1%7C39%3A1%7C240%3A1318

At least I could use the picture as a template to duplicate them in stainless.

[muscle_Car1]

Wow I have one just like that for my festy... From Australia to boot.

[bravekozak]

forget it

The E5 exhaust is way smaller than the B6.
bolt hole centre distances in mm.

165 vs 176
75 vs 105
60 vs 74
240 vs 277


As I stated previously, the picture will have to serve as a template for runner lengths of equal distances.

Muscle_car, are your headers made by Genie?

[Biff]

is there a Header pipe kit you can buy and do a build your own header?
I thinking I would like to try that!

[festivaWES]

nope....no kits.

[sasquatch]

is there a Header pipe kit you can buy and do a build your own header?
I thinking I would like to try that!

just go out and buy a copple "U" bends and start hacking them up.. thats what i did and it turned out ok. but i did a rush job.... and not happy about that