Tweet
Hey can someone with a FMS hood do me a big favor.... I need to know the measurement from the front of the hood to where the raised part starts. I also wondering is there any supports or anything on the underside of the hood or is it just smooth fiberglass. Thanks a bunch.
-
90 festiva BP/G25MR swap, spec v seats, aspire brakes, FMS springs, round headlight conversion with HID's, custom exhaust, fiberglass hood, and a whole lotta bodywork
BEFORE
AFTER 
-
The raised section starts about 3.5" from the front... There is some built in "reinforcement" type material on the bottom of my hood, but it could be beefed up a bit. Even with 4 hood pins and rubber hose to make it as tight as possible, my hood still dances quite a bit at highway speeds.Simon - pimptiva.com -
k thanks a bunch. I needed it to start before 5 inches so it would clear the rad cap, so that sounds like it will work out just fine.90 festiva BP/G25MR swap, spec v seats, aspire brakes, FMS springs, round headlight conversion with HID's, custom exhaust, fiberglass hood, and a whole lotta bodywork
BEFORE AFTER Comment
Comment