Front bumper mod..

[Festiva_Fred]

My front bumper is now tucked in about 1/2-3/4" closer to the body, heres how I did it.


I used a nail and a hammer to make pilot holes for drilling new holes



Where I marked it on the top


Bottom


New holes drilled






And mounted














Keep in mind that this is NOT a perfect fit, and some of the clips won't line up anymore, but even with that I think it looks nicer IMO.

[Maxtiva]

You should do this with the rear bumper also

[Festiva_Fred]

You should do this with the rear bumper also

I plan to, the rear will be more complicted though..

[Festiva_tunner]

I kinda like it - did you have to remove the foam behind the bumper?

[Festiva_Fred]

I kinda like it - did you have to remove the foam behind the bumper?

It's removed right now, but I think you could still use it if you trim some of it off. I'll see if you still can later..

[sam.1956]

That looks way better than stock, IMHO! Nice work.

[Festiva_Fred]

That looks way better than stock, IMHO! Nice work.

Thank you!

[sasquatch]

that looks very nice i would do thid to my car but that would leave less room for my intercooler... lol. nice work, keep it up

[Festiva_Fred]

that looks very nice i would do thid to my car but that would leave less room for my intercooler... lol. nice work, keep it up

Thanks sasquatch!

[Damkid]

That does look pretty good like that!!

[Festiva_Fred]

That does look pretty good like that!!

Thanks Damkid!

[JPT]

That looks real good like that!

Now, flush mount the turn signals.

[Festiva_Fred]

That looks real good like that!

Now, flush mount the turn signals.

Thanks! I will probably do that also.

[FestYboy]

how did you address the foam supports behind the bumper cover, as well as the weel well corners?