Bodykit

[glacius182]

Just to let you know that I ordered my ATH bodykit today. I'll receive it next monday. Can't wait to have it!!!!!! Cost me 1605$ with taxes and shipped to my door. For one time I'm saving money by living in Canada :twisted:

[88FESTIVAGTR]

yikes, they raised the price a bit

[SimonTuffGuy]

Did you get it from FMS or the ATH importer from Canada?

Simon

[MY5TERE 1]

Will any other kits fit on the Festiva?

[SimonTuffGuy]

Not without some type of modification.

Simon

[MY5TERE 1]

what cars are close to the same size(width) as ours??

[EVOGUN]

If you check back, I should have some pics up next week of the conversion I'm been busting my ass on. And your question will be answered.

Thanks :wink:

[glacius182]

Directly from the ATH importer in Canada, because I'm living in Canada! It would have cost me a lot more to get it from FMS. I'll have to order over 1000$ form FMS next week or so. As soon has I receive my kit I'll take picture of both the car and the kit. (I did not sleep since I order it :mrgreen: )

[BLiNdSiDe]

Hey good job! hope to see that this summer... ;P

Btw does the ATH kit is made of ABS or fiber-glass?

[SimonTuffGuy]

The ATH kit should be in fiberglass, even from ATH.

The GTX kit came in poly-eurethane...

Simon

[glacius182]

What's the difference between fiberglass and poly-eurethane?

[SimonTuffGuy]

Fiberglass will crack where poly eurethane will have more give to it...

Fiberglass is usually cheaper, because it's easier to make. Poly-eurethane is harder to paint and keep paint on it, it needs to be prepped correctly.

Fiberglass is usually lighter too.

Simon

[glacius182]

Thanx for the infos, I'll be sleeping less stupid tonight.

[glacius182]

I just receive my bodykit!!! Can't wait to begin the work but I've got a question for the maniacs, look at this picture :



It's the rear bumper for those who didn't see it :wink:
Here's my questions:

Why is there a hole on the left side but not in the right one?
What's this hole for?
Is there suppose to be a hole there?

I sent an email to NewState (ATH distributor) to learn more from this hole.
Thanx

P.S. I've got a website with more photos www.rafaruto.com and you click on Festiva Project on your left, sorry guys but for now only in french.

[SimonTuffGuy]

It's for a reflector that they used overseas.

There should be a place in the other side for a hole to be drilled.

FWIW, Could you get me dimensions of the size of the hole and the locations on the bumper (in from the side and from the top to where it's at.) I'm interested in putting a set in there.

Simon