Creative Cup Holder Ideas

[mckabe]

Here is my protege one. Notice how I filled the gap with card board. I then went and epoxied carbon fiber on the sides and front.

http://i1141.photobucket.com/albums/n592/mckabe21/IMAG0039.jpg

http://i1141.photobucket.com/albums/n592/mckabe21/IMAG0026.jpg

[fastivaca]

Go to page two of my Cardomain page to see the Protege cupholders. The link is in my signature.

[TominMO]

I have a protege one and will never do anything else, best cupholders ever.

Big +1.

[navdoc101]

I've been lookin' for the Protege one for a few months now. Can't find one anywhere. They are the best. Love the hidden behind door deal. Very clean lookin'

[mckabe]

I can get some pictures tomorrow for ya

[htchbck]

I'll have to post up pics of the one I made for my Grumman LLV at work. According to a co-worker its "certified ghetto-fried". But for the festiva the way to go is the Escort console. I do use the "between the e-brake and seat" a lot too, as well as the "pull out the ashtray behind the ebrake and stick a 12oz Dr. Pepper in there"

[DriverOne]

I have a protege one and will never do anything else, best cupholders ever.

Pic? Thread link?

[mckabe]

I have a protege one and will never do anything else, best cupholders ever.

[jamesmc]

about what year was the escort. If i remember right they changed between 90 and 91.

91-96

[newfestiva]

About what year was the Escort. If I remember right they changed between 90 and 91.

[25Horseplay]

I just shove my cup between the pass seat and E brake!

[NicholasJackson]

I've seen lots of youtube videos of festys with a clip on cup holder hooked to the far left air vent or in the top seam of the door trim.

Yeah mine came with those.

[Basement_Modder]

I've seen lots of youtube videos of festys with a clip on cup holder hooked to the far left air vent or in the top seam of the door trim.

[DriverOne]

I love the new GM one that is vertical in the dash and when you push it, a ring flips out of it as it settles down.

[sasquatch]

in my tracker i took a piece of exhaust and welded a piece of flat bar to the bottom and used self tapping screws to mount it to the trans tunnel lol...