isuzu stylus bumber installed!

[fastivaB6TG25MR]

it hides teh intercooler quite well

[getnpsi]

Oh wow looks nice but at the same time I think all the holes don't match well with the festiva grille. Maybe a cutout and floating emblem treatment?

[fastivaB6TG25MR]

im looking fro a kia pride grill... thinking that will look better. or maybe round out the ends of that grill to match the bumper

[Damkid]

Looks like a nice install, looks good :thumbright:

[bobbyspider]

well... im jelous. you got one of the fastest stivas yet and now your going for best looking looks good bro

[Grey Vw]

Just keeps getting cooler by the day. Better hope those zip ties don't break.

[bobbyspider]

^ha ha i didnt notice that till you said somthing

[lanemeyer14]

Lookin good

[hotfordcat]

im looking fro a kia pride grill... thinking that will look better. or maybe round out the ends of that grill to match the bumper

I have the late model grille, headlights, and bumpout side marker lights. Not the fenders.

[perucho]

That was quick!

[sasquatch]

hell ya!!! that looks AWESOME!!! any pics of how you mounted it on there?

[fastivaB6TG25MR]

That was quick!

my old bumper cover was already off and i had it sitting in place when i texted you... i cut a little too much off and had to learn how to plastic weld... im gettin better at it

hod did you make your turn signals fit in the bumper holes? the back part where the plug is doesnt fit at all. it hits the metal bumper. those are just the lens' no lights

how i mounted it:

i cut off all the raised edge so it was completely flat on top

i took a cut off wheel and relief cut all the horizontal bracings on the back side to make it flex so it would square up to the front of the car(the damn stylus was alot more ropund than i thought it would be)

i measured out the center and drilled 2 holes in the bumper and in the support so when i pushed the bumper flat against the support i could bolt it down. most of the parts are still heald on with zip ties but it doesnt move at all. when i take it back off to plastic weld the back side ill take pics.

[lanemeyer14]

hod did you make your turn signals fit in the bumper holes? the back part where the plug is doesnt fit at all. it hits the metal bumper. those are just the lens' no lights

Not sure how others did it but I used the original festy turn signals (with camry clear lenses) because of the issue with the Stylus lights hitting the bumper beam. I cut out the black "filler" pieces on the sides of the light from excess pieces of the Stylus bumper and just screwed them in place....

[perucho]

Not sure how others did it but I used the original festy turn signals (with camry clear lenses) because of the issue with the Stylus lights hitting the bumper beam. I cut out the black "filler" pieces on the sides of the light from excess pieces of the Stylus bumper and just screwed them in place....

I did the same but used the stock festy lenses too. Had to cut and "massage" some of the Festiva black metal bumper to make everything fit fine. Can't remember what I did to the stylus skin to fit the lights though...

[fastivaB6TG25MR]

ill figure something out... im hoping by this weekend