Is there a 5 lug hub/rotor swap you can do?

[RhodeStiva]

^Just the hubs\rotors, maybe from a newer ford or honda?

[Damkid]

None that I know that would be a direct replacement, most likely any 5 lug hub would require custom axles (to fit the spline count)

But why go through all that just for another lug nut?

[Bert]

None that I know that would be a direct replacement, most likely any 5 lug hub would require custom axles (to fit the spline count)

But why go through all that just for another lug nut?

I quite agree there. I don't know why 5 lug has become so fashionable for econoboxes aside from planned obsolescence of older drivetrains. Once you've done the Aspire swap to 100mm (from the Festy 4 1/2 inch) there are hundreds of choices for rims already. I bolted on VW rims initially (required a hub centric spacer ring) but ultimately found that Kia Rio stuff is a direct fit. Now I'm running 14s with no rubbing or interference (with spring perches) issues at all. No doubt there are compatible 15s out there too but lo-profile tires will be pricey.

[RhodeStiva]

I was just wondering how easy. but the way it sounds your right to much trouble.
(there is just so many rims i like and the bolt pattern is five lugs)< Not worth it though i will just wait for the right ones.

[eurotiva]

you can find pretty much any wheel in both 4 or 5 lug, but i'll agree that some wheels look better with 5 lugs, say on a 5 spokes

Other than looks, I'd say it isn't worth it to do

[RhodeStiva]

yea i seen these blue wheels ob CL i really liked that's why i asked .
I look them up on internet and they only make them 5 lug .

[Nerd Racing]

look into a mazda protege5. you will need to tweak some things for alignment though. And swap to escrot tie rod ends (that is just up front) Rear who knows?

[Aspire SVT]

I've been wondering about this too. The aspire hubs are too small to drill to 5 lug ( not enough area would be left for strength) and aftermarket hub adapters would kick the wheel out at least 1+ inch and create more possibility for unbalanced rotating mass and unsprung weight. There are some really nice looking 5 spokes I'd love for my new one but they also only come in 5 lug patterns. I'm certain a machine shop could make front hubs to fit the spindles. Have to do some jy measurements to see what 5 lug rotors would fit or re drill the 9 1/4 stockers. I'm subbin this thread.

[Kraig]

Maybe Probe parts?