Q's bout Rear Polys

[bondo]

Just got these in and They look to long? does anyone know how they go in? thanks

http://www.polyperformance.com/rally/Synergy-Suspension-Bushing-Kit-p-16605.html

PPM-4300-200

[Hot_Wheels]

can you post a actual picture? are they in a sleeve?

here is what the stock look like


i used a harbor freight press and some round stock with a little lite silicone spray to install them. I stated them in with a C clamp but could only get so far, it was much easier with a press.

[bondo]

Heres what they look like:

[bondo]

I got the old bushings out easy with a big c-clamp, and Im now painting the rear axle, I found out the outer sleeve comes off haha and now it makes more sense from what the write up says. Should be finish with it soon

[sketchman]

So these fit a stock beam? No mods?

[bondo]

Its the aspire beam and yeah theres mods: follow this

http://www.fordfestiva.com/forums/showthread.php?35592-Torsion-beam-bushing-measurements

This is the write up, just got to trim the bushing and the inner sleeve and need a bigger bolt and nut

[sketchman]

Thanks. Another job on the list.

[bondo]

haha yeah no worries, same here my list of mods to do to my car is endless haha

[bondo]

Alright so I cut my bushings to size but cut alittle bit to much, should that be a problem?

[bondo]

Just got some pics of the bushings installed, I had to go and get 2 5/8 in bolts and nuts at napa. Here are some comparisions between the stock and the new. It seems pretty legit but lmk if you see anything that would be a flaw. I also want to know if the 3mm shims would be necessary? thanks

[bondo]

Does anyone know if I drill the hole bigger on the mount that mounts to the body that fits the 5/8 bolt through, If I drill that hole not center can it cause the car to be crabbing a bit?

[Bert]

Them's big bolts lad! If you come in from each side of the brackets I don't see how you can mess up centering the holes.

[sketchman]

If in doubt, use a step drill.

[Mustangman16]

Bondo is that a Toyota axle sitting on the floor?

[bondo]

Sweettt right on thanks guys just need the encouragement and to make sure haha