1988redfordfestiva tryin to fix her up

[1988redfordfestiva]

well tonight i noticed a hose wasn't in the right place now i need to figure out where the for copper lines coming out of the carb go to and these 2 sensors i took pics of i have no clue if my hoses are right i also look at the vacuum diagram shown on the page was a little help any one with a carb that can show me would be good mtec has also helped me cover most of this to once i know where they go i will write a full dialog on the hose and locations with pitures so the moderator can have up here on the site

[1988redfordfestiva]

heres a video so u guys understand what I'm talking about

http://www.youtube.com/watch?v=siQgD9qOhRs

[anomoly40]

Ironman 2?

[1988redfordfestiva]

sorry wrong link heres the proper link

http://www.youtube.com/watch?v=tBcFUl-Nrpw

[anomoly40]

I looked in my manual but itsnot in there.

[1988redfordfestiva]

trying to get it to run right so i can drop out the engine trans out one last time and sand down the engine bay and repaint it so it can look nice

[1988redfordfestiva]

Well i have given up now just gonna finish the body work and rip out the engine.

My next step is look for an EFI motor.

Will a 95 Ford Aspire Engine fit?

[FB71]

square box labelled FE89 is the MAP sensor, get connected directly to manifold vacuum, below the carb.

round one on passenger side is the Wide Open Throttle Vacuum Switch, gets connected to the same place as MAP.

[1988redfordfestiva]

yeah i have them hooked up right now and the rest engine idle up and down its the carb finally figured it out and now as of this morning i called a junkyard for the 97 aspire head and complete wire harness and fuel pump $175

[TheresGabe]

I've bought good running complete Aspires for $190...

[1988redfordfestiva]

well here are the latest pic of the restore process