Tweet
Explain..^?
The sway bar is going to eat threw the aluminum?
The sway bar is going to eat threw the aluminum?
-
-M3NTAL MARK! Woo!!
-
Dont worry its an inch away from it and its an aspire sway bar its above the crossmember at that section
Heres the first start !!!!!!!
First try
93 L B6T DD http://www.fordfestiva.com/forums/sh...ad.php?t=37751
RIP_90 LuX http://www.fordfestiva.com/forums/sh...ad.php?t=32249
RIP 88 LX / B8-MEhttp://www.fordfestiva.com/forums/sh...ad.php?t=26398
RJ
Comment
-
Nice. Congrats on alot of hard work.-Greg
Euro-bprt...WORLDS FASTEST FESTIVA !!! 11.78@115.9
BP, G trans, Megasquirt/ 550cc inj. t3/t3 (tbird) Garrett, REAR TURBO!!!! AND AC!!!!
Redneck Engineer
FOTY - '09
5x Festiva Madness Attendee...FM 3,4,5,6,8
http://www.youtube.com/watch?v=LpCZ7...9Pwqw-oe8s2OYQ
http://www.youtube.com/watch?v=vU_eX...9Pwqw-oe8s2OYQComment
-
Thanks Greg, it was nice meeting you yesterday too. I had a blast, you've got a nice family.-M3NTAL MARK! Woo!!
Comment
-
Very nice :thumbright:
1988 323 Station Wagon - KLG4 swapped
1988 323 GT - B6T Powered
2008 Ford Escape - Rollover Survivor
1990 Festiva - First Ever Completed KLZE swap (SOLD)
If no one from the future stops you from doing it, how bad of a decision can it really be?Comment
-
Shift Linkage:
Took the Festiva linkage and cut the end off. Then cut the end of the Capri linkage off slid it over the Festiva linkage and mocked it, drilled a hole threw it and put a stainless hardened bolt and nut threw it and wall-la shift linkage no weld.
Did the same one with the solid rod.
-M3NTAL MARK! Woo!!
Comment
-
Battery relocation to rear:
14ft 2 Guage power wire
JL Audio Distribution Block
Kicker 0 Guage Ground
-M3NTAL MARK! Woo!!
Comment
-
Drove her to work today
-M3NTAL MARK! Woo!!
Comment
-
Well............ any kinks to work out yet?
1988 323 Station Wagon - KLG4 swapped
1988 323 GT - B6T Powered
2008 Ford Escape - Rollover Survivor
1990 Festiva - First Ever Completed KLZE swap (SOLD)
If no one from the future stops you from doing it, how bad of a decision can it really be?Comment
-
Yeah this one
Traction problems ?? I think so...
-M3NTAL MARK! Woo!!
Comment
-
:shock: too many burnouts?!?!
1988 323 Station Wagon - KLG4 swapped
1988 323 GT - B6T Powered
2008 Ford Escape - Rollover Survivor
1990 Festiva - First Ever Completed KLZE swap (SOLD)
If no one from the future stops you from doing it, how bad of a decision can it really be?Comment
-
.... With a condition like this I would have thought it obvious.
.
Originally posted by M3NTAL View PostYeah this one
Traction problems ?? I think so...
A hunch is creativity trying to tell you something.
Comment
-
-
Don't you just hate rhetorical questions?Ian
Calgary AB, Canada
93 L B6T: June 2016 FOTM
59 Austin Healey "Bugeye" Sprite
"It's infinitely better to fail with courage than to sit idle with fear...." Chip Gaines (pg 167 of Capital Gaines, Smart Things I Learned Doing Stupid Stuff)
Link to the "Road Trip Starting Points" page of my Econobox Café blogComment
-
Don't you^^ just hate me???
Changed my oil today after putting 2 miles on my car..I know I should of changed it right after the first heat cycle but 2 miles didn't hurt
Shell Rotella T SAE rated oil 15w 40 and a Napa gold Oil filter ! Reading 40-45 psi on cold start up ! Give her a rev and it's close to 60! Yes!!!
So fresh n so clean clean
-M3NTAL MARK! Woo!!
Comment
Comment