custom tail light filler neck

[seniorsteele]

i remember a while back that someone had a filler neck behind the left rear taillight. i think it was simon but im not quite sure. my question is what type of material did he use to get from the filler neck to the tank?

[SimonTuffGuy]

It was my car... Had an exhaust shop bend a piece of metal tubing to the contour of the floor (around the strut tower) and then just used rubber hoses and clamps to hold everything together.

The filler neck was the same assembly that was cut from the side of the car, welded in place and then puttied so that it would stay sealed. Small modifications needed to be made at the end so the plugs for the tail lights had room to fit.

I have pics somewhere on my laptop if you need more details.

[Gomez]

...I have pics somewhere on my laptop if you need more details.

I need more!

[seniorsteele]

Had an exhaust shop bend a piece of metal tubing to the contour of the floor (around the strut tower) and then just used rubber hoses and clamps to hold everything together.

cool i was just thinking how cool it would be on anything where a clean look was desired. i just couldn't. thanks think of the material

[Deathshead]

im going with one of these, going to look sick!


TINY please ...

http://tinyurl.com/2hvho3

[Festiva_tunner]

[quote="Deathshead"]im going with one of these, going to look sick!


You can buy it cheaper at a local parts store


Simon could you make a thread in the mods section I know I would like to do this along with shaving the handles . . . plus I'm sure there are more that would like to know as well