never mind

[Gforcefd]

...

[darpien]

disconnect every connector for the wiring harness, take off the wheels then the struts. take off the axle lock nut, pull the axles out of the transmission(before doing this drain the tranny by unscrewing the bolt on the bottom of it should be in a rectangular hole in the crossmemeber). you should now take off the exhaust manifold by taking off the heat shield then undoing the bolts that hold it on the engine and take off the bolts holding it on the exhaust tubing. then you should drain the radiator by taking the drain plug out of the bottom of it(shouldn't be hard to find since it is the only plug on the radiator and it is on the bottom and made of white plastic but if you can't find this you could always just take the bottom hose off but you better have something big enough to catch all the fluid that will be spilling all over the place. then there are 2 hoses going from the rear of the engine to the heater core just take those two off as well as the pipe that goes to the bottom heater hose and the heater core. if you have any accessories like power steering or a/c make sure to unbolt the pumps now. then you have to unbolt the 3 engine mounts one located on the passenger side the other on the front of the transmission and on the front part of the crossmember the other on the rear of the transmission which is on the rear of the crossmember(you can only get at it from under the car and it is only 1 14mm bolt that you have to unscrew which can be located through a small hole in the crossmember). while you are undoing the engine mounts you should have a engine hoist positioned and have it so it is supporting the engine so that when you start undoing the mounts it won't fall on you. then it should come out. installation is directly opposite of removal well unless your dong a swap.

[Gforcefd]

picuters

...

[hellraiser6919]

go to the parts store and buy the festiva and aspire manual, they have pics.