on the bay

[Gomez]

I would like to have a new quad squirter (you know the one that has 2 holes in the squirter for each wiper. came stock on my 91) for my dd. Know of one?

[bravekozak]

Anybody ever blow a head gasket?

Nice alloy wheel caps.

Nice double squirter.

[jawbraeka]

I wonder what this grille would look like on a Festiva?
It would be a shame to chop down an original.

Nice center cap.

Photoshop is your friend. ID also consider round headlights like the cars of that era to fit in the 'chromed' look.

Sent from the depths of hell.

[bravekozak]

I wonder what this grille would look like on a Festiva?
It would be a shame to chop down an original.

Nice center cap.

[jawbraeka]

only thing still showing up from kia is the pads for holding wiring along the roof seems to still be avail from kia dealers. KKY02 67 078A. i think this would be the thin adhesive patch with a soft foam face. the ones used on wiring along the floorpan MD002 67 061 don't show up. maybe a craft supply store might have something suitable?

I'd just use the roof ones for the floor unless you're a complete purist at heart.

sent from the depths of hell.

[bravekozak]

This R/H outside belt molding has been discounted 23% below MSRP.

Too bad there are no L/H 79s.

[bravekozak]

Too dear for me.

[bravekozak]

Expensive single roll.

Four rolls of Polyken electrical tape

A few more rolls for a group buy.

I wonder if this stuff could be used for sound deadening?

Single keys usually go for $17 + shipping from Four Green. $70 for a full set.

Can always use these.

[bravekozak]

Nice seats.

RX8 seats.

[bravekozak]

gas mileage calculator

[bravekozak]

'69 Mustang

[F3BZ]

only thing still showing up from kia is the pads for holding wiring along the roof seems to still be avail from kia dealers. KKY02 67 078A. i think this would be the thin adhesive patch with a soft foam face. the ones used on wiring along the floorpan MD002 67 061 don't show up. maybe a craft supply store might have something suitable?

[bravekozak]

Actually, It's more to prevent rattling while moving down the road. Manufacturers use a lot of wire looms and foam to wrap loose connectors. There are even connectors with barbs. This bracket provides a positive anchor for a future install. All the wires are cut by a machine to make a wiring harness. That's why they won't have a separate wiring harness without radio wiring.

Notice it has a dock for the unused connector on the back of the radio. It becomes live when you turn the radio on. I still haven't figured out what it was for. Power antenna relay?

F3, do you know where I can buy some routing tape? Those pads that stick the wiring down under the carpet.

[F3BZ]

NOS Radio Delete?
http://www.ebay.com/itm/ONE-FORD-198...e38e27&vxp=mtr

that's the correct part. too bad these don't come with the terminal parking bracket that was screwed to the back of the ones that came in a car with radio delete. this was a plate to park the unused terminal end of the radio wiring harness. keeps things tidy back there.

[bravekozak]

grease cup

rear emblem

shifter knob

lock cylinder