What have you done to your Festiva today!?

[rockin86ranger]

Got my shifter made up (Still need to make a boot for it) unfortunately when i went to put it back together i gave the locking spring a slight tap and watched the shifter fall through the floor. So i will fix that tommorow and finish the install. Hopefully it will tighten it up enough to keep the shifter out of the steering wheel (yes steering wheel) I don't really want to have to bend it, it's already a little close to the passenger

[Team Lightning]

Installed my new Decals!!

[navdoc101]

Over the last couple o' days installed a Protege console/cupholder.

[crazyrog17]

I put two new Kumho 155/70R12s on it to complete the new set of shoes she's wearing. Getting fed up with the gas mileage and the transmission whining when I let off and coast. The two problems might be one as there could be a bad output bearing it the trans.

[rockin86ranger]

Fixed the shifter falling through the floor, waiting on my aunt to get the boot sewn up to take some pics of the shifter, painted one of my wheels (didn't have enough time to swap tires and paint the others), had a full exhaust put on (all new except the manifold and the first 10inches of pipe), tightened up the wheel bearing on the passenger rear. I think i have a motor mount out, need to price one and see if i can replace it, also need to think about putting a cv shaft on the driver side. Also going to try and do some sound proofing on it this weekend, if i get the time.

On a side note it was fun to play around without a muffler on it for a bit.

[juanj0]

installed the fog lights with xenon 6000k

[smurfstiva]

I put all new fuel lines, clamps, filter, and pulling front springs off my 93 to put on the rear along with a corrected beam. new tires should be in wed.

[walth]

just pulled my b3. took 2.5 hours or so. now time to clean the bay and replace some seals on the tranny and then 1st gen b6 going in

[Charlie1717]

installed the fog lights with xenon 6000k

Where did you get those? I've been looking forever for well fitting fogs/driving lights.

[juanj0]

Where did you get those? I've been looking forever for well fitting fogs/driving lights.

here

http://shopcustomcreations.com/2-Round-Metal-Universal-Driving-Fog-Lights-B2045/prod-2348.html

[link5186]

Drove it south to Louisville to snag about 80% of a suspension swap. Rio front and aspire rear.

Sent from the bathroom via crapatalk

[Pu241]

Added 2.3 Quarts of ATX fluid to "top it off".

[Christ]

The the 155/80R13's on it to see if I could reorient myself with it. Took it for a drive, lost alternator belt and it died at a left turn when the light turned green. What a damn car...

I might still have some feelings for it. Maybe.

[jemartin144]

replaced thermostat. forgot to get a gasket, so a little leaking til tomorrow. replaced valve cover gasket, broke a bolt because apperently its only tightened to in-lbs, not ft-lbs. fail x2.

[AJboy775]

sent the B3 block and head to the shop to get honed and machined and milled