picked up a few shop goodies

[Guest]

Went to HF and got some shop goodies..

This Jack.. (no more lifting the fender well to get a floorjack in a good place.

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=91039

The 750lb engine stand.. Techno's BP should be here in a couple of days..

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=32915

and a 12.00 set of jackstands.. the turbo car is using my other 4 right now.

[getnhi1]

So is there a HF around there now, or did you drive out to 290?
We have one here.

[ericsmith32]

Nice goodies.. i'm not allowed to buy any more tools till we move and build a gigantic shop that is

[freshtiva]

jacks

I bought a craftmans 3 ton floor jack from sears a couple of years ago. It came with two three ton jack stands and two wheel chalks for $99.00. They may be more now but I saw the same offer less than a year ago. Its model #875.501390. Its not aluminum and doesn't have 360 degree saddle though. Just a thought, mines been a good one. Engine stand will make changing those oil pan gaskets easier.

[freshtiva]

OH yeah sears jack goes up to 19 inches

[Rumnhammer]

jack

I just bought the bigger version of that jack at HF last month. The larger one doesn't go on sale as often as that one so I jumped on it.
They are pretty nice, I also got a load leveler for my engine hoist as well.
Doing the Skyline swap was the motivation for these, and both have come in handy as well.
Chris Rummel

[SimonTuffGuy]

Nice DJ. We need to spring for one of those too. My brothers Z is pretty low and the jack we have now sucks and doesn't work on my Jeep. I picked up a high-lift, but it's pretty dangerous, haha...

[Guest]

So is there a HF around there now, or did you drive out to 290?
We have one here.

Yeah in Pasadena, where K-Mart was at Red Bluff and Spencer..