making a trip to the junk yard

[mikeyjd]

Post if you need something.

[Prafeston]

brave needed a connector. He just asked me about if I was going back to the yard soon to grab it for him. Maybe you can help out though. Not sure when I'll be back next.

"If you are going back to that yard, I need you to snip out the 10 pin male/female connector pair that join the front wire harness to the rear wiring harness. It iwould be located just under the ECA computer. It has a lot of green wires for the rear taillights. If you could cut a few inches either side."

[mikeyjd]

brave needed a connector. He just asked me about if I was going back to the yard soon to grab it for him. Maybe you can help out though. Not sure when I'll be back next.

"If you are going back to that yard, I need you to snip out the 10 pin male/female connector pair that join the front wire harness to the rear wiring harness. It iwould be located just under the ECA computer. It has a lot of green wires for the rear taillights. If you could cut a few inches either side."

lkq scrapped their festy since the last time I was there :/ At leasy I got a few things I needed off it last time...

[mikefrazer]

I am looking for a passengers outer door handle

[RhodeStiva]

ford taurus cup holder
$T2eC16N,!zUE9s389zcKBR)R444sEw~~60_1.JPG

[Larry Hampton]

Rhode, I have a Taurus cup holder on my bench. I'm driving to Florida on the 10th, leaving OKC about 9ish am, probably be early early morning when we went past Destin. Headed to ESPN Wide World of Sports at Disney. I have two sets of Festy Spindles that I was going to ship down to whomever rebuilds them as well, was kicking around bringing them along to drop off with someone who knew whomever was rebuilding them.

[RhodeStiva]

Rhode, I have a Taurus cup holder on my bench. I'm driving to Florida on the 10th, leaving OKC about 9ish am, probably be early early morning when we went past Destin. Headed to ESPN Wide World of Sports at Disney. I have two sets of Festy Spindles that I was going to ship down to whomever rebuilds them as well, was kicking around bringing them along to drop off with someone who knew whomever was rebuilding them.

don't know who rebuilds them have a couple shops near me. and destin might be out of the way but if you wanted to i would trade you for my to front festiva spindles and shocks for the cup holders if you come by here.

[RhodeStiva]

I could meet you a I-10 at defuniak springs exit.

[Flyin4stroke]

I could meet you a I-10 at defuniak springs exit.

Did you just sneeze^

[Larry Hampton]

I'm hoping to meet up with you too Flyin...

Rhode, someone in Florida or Georgia was asking for cores and rebuilding them. I've got two sets for cores, never been apart so the shims should be in the correct locations.

[Flyin4stroke]

I'm in Orlando. I'm sure someone could use some minty parts.

[RhodeStiva]

i don't know might have been POWERSTIVA. but i dont think he lives around here anymore.
but if you wanna make that trade i will give you both complete spindles and all or how much for the cup holder.

[Chobobulous]

I thought zoom zoom rebuilt them. He is in Florida correct?

Htchback (sp) is in Georgia, the northern part i believe. He rebuilds them too.

[zoom zoom]

I can/ do but I'm in Ohio and nobody seems to be in need. Festys really need new rotors too so its not worth doing just to have a set laying around until someone it needs done.

[Studebaker]

larry would you have a good 5 spd trans. Are you coming thru Memphis?

David Hodges