Tweet
how has everyone installed there spoilers? When i pulled it off the car it had some plastic anchors. Should i use some of those, or just metal screws? Any measurements or anything for lineing it up?
-
89SX funtop! Fully loaded!
RIP 90LX
-
i didn't have the plastic anchors, so what i did was held the spoiler where i wanted it on the hatch, took a pencil and marked inside the bolt hole, so when i took the spoiler off i had 4 pencil marks on the hatch and drilled the holes, and bolted the spoiler on
thats how i did it
1988 323 Station Wagon - KLG4 swapped
1988 323 GT - B6T Powered
2008 Ford Escape - Rollover Survivor
1990 Festiva - First Ever Completed KLZE swap (SOLD)
If no one from the future stops you from doing it, how bad of a decision can it really be? -
I would recommend using stainless steel screws.Ian
Calgary AB, Canada
93 L B6T: June 2016 FOTM
59 Austin Healey "Bugeye" Sprite
"It's infinitely better to fail with courage than to sit idle with fear...." Chip Gaines (pg 167 of Capital Gaines, Smart Things I Learned Doing Stupid Stuff)
Link to the "Road Trip Starting Points" page of my Econobox Café blogComment
-
I just lined it up drilled holes and used stainless screws. I also put some RTV sealer under it so it didn't leak.Comment
Comment