Aspire Blower Motor

[timmytooth]

I have an issue with my aspire's blower motor. Motor works if I plug in directly to 12v and ground, all resistors are good and both the blower breaker and wiper fuse are good. I tried jumping the wires at the switch to no avail.

Does anyone know if there is or where the relay is located in the dash loom?

Getting very upset here, any help would be greatly appreciated!
:?:

[phantorn]

Its 1 of the 3 relays by the washer jug under the hood.wire colors power-bl/gn and w/gn.ground bk,out put to blower r,check ground 202 behind kick panel passenger side.verify you have power or not ant blower wire coloris red.(do not just use a test light it does not have enough load use a 3157 or1157 bulb)If power verify ground side of motorground the BL/w wire and see if it comes on.Use a straight jumper wire for this not a test lamp or the jumper I talk about.BTW the control head also shares ground 202 along with several other things
I can fax a you a wiring diagram if you need it.

[timmytooth]

I have the wiring diag. from my Haynes, but does not show a location for relay. Grounds look okay, but I will check again. If you have a better wiring diag. than the Haynes I will take it.

[phantorn]

factory wiring diagram need fax #.I cant stress enough to load test these circuit you could have 1 strand owire left and it will light a test lamp but not carry aload......

[timmytooth]

I found and fixed the issue. You were a great help. It turns out that 3 out of 4 wires were coroded off. I crimped some new ends on, and let there be heat!!!

[phantorn]

Kewl Beans !