Front bearings with Aspire swap

[gottafesty]

I did a search for this but couldn't find anything that answered the question I have. I've already pulled the bearings and races and have the new ones ready to install. Now I'm stuck. Do the bearings need pressed in or are they slip fit? If they are pressed, does anybody have a procedure that I could follow. Haynes manual didn't address the front bearings and I don't have an Aspire shop manual. Any help would be appreciated since I took my car out of service without knowing how I was going to get it rolling again. ops:

[dahodges]

Its a press fit. You can do it with a hammer and right size socket. Over one inch I think.

David

[Unicornasaurus]

The Hayne's manual doesn't address front bearing removal because you're not supposed to do it yourself

[gottafesty]

[qaking]

PM sent gottafesty.

[gottafesty]

Got it, sent you an email qaking.