aspire rear wheel cylinders any one else have a problem??

[Hot_Wheels]

so im rebuilding my rear aspire axle beam, putting all new parts on. Im having problems with getting the new drum wheel cylinder bolt holes matching up with the drum shield. has any one else had this problem? there like a 1/8 inch off and i opened the holes up a little but i really dont want to have to open them up any more. i tried calling around to see if anyone else has any localy but everyone is special order right now grr. i dont know if its a bad part or just a typical problem.

[mechanicaldj]

sounds like wrong parts

[garylau]

I just saw a post where someone discussed this like 2 days ago. I can't remember where I saw it, but I know he ended up drilling the holes out a little bit, but I guess you already tried that.

[Hot_Wheels]

yea it was probably me, i just made the hole a little bigger

[Sandm849]

Yea I ran into it once....I got the cylinders from a local warehouse and they were off. returned them and got other ones at autozone and slid right in.