pillar trim (is this right?)

[doi_doi]

good day again festivas!

i just want to know how to take off the pillar trim in between the windshield and the hood?i want to repair the inside part coz my car is flooding everytime it rains.and how to install it back?any adhesive will be used?
thanks!.

here's the photo:

[Safety Guy]

I don't see a photo.

Karl

[bravekozak]

Probably just a snap fit. Pry up very carefully with a wide trim remover tool.
I believe there are three retainer posts on each A-pillar.

[doi_doi]

@safety Guyk sir, ill post it again right away..
@bravekozak:thanks sir..is there a same thread here in the forum?what kind of adhesive/silicon like to used in installing it back?
more power to you guys!

here's the photo again:

http://img714.imageshack.us/i/eb20010xh.jpg/

[DrMaxwellEdison]

never seen anyone take the cowl off.... if I'll looking at the picture correctly that's what I'm seeing

[batstiva]

never seen anyone take the cowl off.... if I'll looking at the picture correctly that's what I'm seeing

x2. I've never heard of anyone taking that off. At least without a torch.

[xaero_81]

Did you take the fenders off yet? I've always assumed it was bolted down under the fenders or on the backside of the dash.

[DrMaxwellEdison]

I had to replace my fender on my passenger side once before (on the Polar Express) and it's factory welded to the frame... there is NO easy way to get that without a torch... thankfully mine doesn't leak... if it did I think I'd take the Wiper motor off and use great stuff to stop the leak....

[stainless1911]

Yeah, I've scrapped out a couple of these for [parts, it ain't comin' off mon.