Tweet
I've lost my keys to one of my cars, got new door cylinders, can't figure out how to remove the ignition cylinder.
-
1963 Fairlane - future NSS drag car
1965 Mustang Coupe - A-code car, restoring for/with my son
1973 F100 longbed - only 22k original miles, 360/auto, disk, PS/PB dealer in dash A/C
1996 Sonoma X-cab - son's DD
2002 Grand Prix - daughter's DD
2003 Sport Trac - 180k, 130k on replaced motor with new timing chains - F/S soon.
2005 Accord - wife's DD
2008 Mountaineer - step daughter's DD
2015 F150 SCrew - DD -
you can use the numbers on the passenger door cylinder to get a new key made.
Short of that....take the plastic off and you will see 2 flat tap screws...no slots. You can cut some slots in them and then you just unscrew them out. Once you do that....everything unplugs."FLTG4LIFE" @FINALLEVEL , "PBH"
89L Silver EFI auto
91GL Green Auto DD
There ain't no rest for the wicked
until we close our eyes for good.
I will sleep when I die!
I'm a little hunk of tin, nobody knows what shape I'm in. I've got four wheels and a running board, I'm not a Chevy, I'M A FORD! -
i need to know the same as well due to we drilled ours so we could unlock the steering. looks like might have to drill some rivets?
Comment
-
There's a very small (tiny) roll pin that holds the cyclinder in, it points downward when installed in car.(paperboy 23) 88 Festy Blue, aspire Engine/trans/efi swap,
Comment
Comment