electrical/ turn signal/ interior "room"

[Jblair]

CAM00338.jpg
Baught a 90 GL this week
Left turn signal doesnt work, both bulbs missing, obviously person knew of the issue, no power at bulb socket, flasher works on rightside.

No dome light, no cig lightr, no stereo fuse ok.

Help? Haynes manuel not very specific

[bravekozak]

Get EVTM that I posted in thread "on the bay".

[Jblair]

I need it fixed asap, any ideas now. Wherr is the flasher?

[bravekozak]

The flasher is with the timer/buzzer and other relays in a tree way up high under the dash above the fuse box. I believe it is the green one.

[Jblair]

If one side works that doesnt mean the other has to work? It makes the click sound. Reading the schematics its pretty clear but there is not a picture of the kid

[bravekozak]

Only one flasher for both. Power flows through the flasher. W/R in, GN/R out. The difference is in the turn/hazard switch, as to which wire the power is shunted to. GN/W for left. GN/BK for right.

If the flasher doesn't work. Nothing flashes. No turn signals/hazards.

==============================

Do you have power to the ROOM and CIGAR fuses?
Did you test both fuses for comtinuity with a multimeter?

If your auto set belts and parking lights work, I would expect you have power to those two fuses, since they are all fed by the same big white wire.

The white wire flows through the ignition switch to provide power to CIGAR.

[Jblair]

Thank you. Belts work, it did check fuse for continuity and they are good. . . I might pull the flasher out of my spare and try it after work. Hazards work on one side also. Ive drove the cat 3days now with no signals, also finding more issues as i drive it. Cant wait till u rebuild all 3 of mine, not a over night thing tho. Need to aspire suspension swap asap too.

[dkuehl]

Mine was acting up, but with the head light. I took the whell off, then removed the entire multi postion switch from the car and hosed it down with WD40. I let it set for about 15 mins then sprayed more. I then took compressed air blew everything off and replaced it. everything work afterwards. The grease inside maybe gumming up the one contact on the turn signals.. took only a few mintues to pull the wheel. Well worth the time to rule out the switch... good luck

[Jblair]

Turn signals good to go. ... sockets spring rusted out, wasnt push bulb in on both, someone had been f`n with it, replace sockets