Announcement

Collapse
No announcement yet.

Idle drops when headlight is ON

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    I would buy some good terminal extractors ( I recommend Hero) and a Dremel with a small wire wheel.
    Remove every suspect terminal, wire wheel them and then push them back into place, one by one.

    Clean the terminals to the alternator first. Then, the grounds.
    Last edited by bravekozak; 05-25-2014, 09:31 PM.

    Comment


    • #17
      yes im done cleaning the alternator + to battery +...

      and the ground, i even tried to put grounding kits

      Comment


      • #18
        I am talking about removing the factory brass terminals from their factory plastic connectors, and even cutting off and reterminating the female terminals where necessary. I have done this to all of my non-sealed connectors and have no problems from being in a salty environment. The flat male spades are easily wheeled.
        Last edited by bravekozak; 05-25-2014, 10:03 PM.

        Comment

        Working...
        X