Tweet
One of the rear drums on my new 91 Festiva has no cutouts where you can drift out the bearing races. In fact the hole on the casting is a bit smaller than the inside diameter of the outer race - no way to tap it out at all. Never seen such a thing! I dropped it off at a machine shop...
-
-
Might be cheaper to buy a new drum than pay machine shop. -
The guy at the counter guessed "five or ten bucks". Told him to call me first before going over that. (The shop guys aren't in today)Originally posted by 25HorseplayComment
-
$10 - they turned it too.Comment
-
That was a good deal!Originally posted by Dave GComment
-
The only way I've been able to get them out is from the opposite side.
The races usually have a little smaller id than the seat allowing me use a screwdriver and a hammer to knock them out..Comment
Comment