Throwout bearing

[Diesel_River]

So I discovered my clutch pilot bearing is bad, while i was in there i am replacing the throwout as well. Although i'm a little confused as to how it goes in, do the two little forks for the clutch lever just rest on the two little forks on the throwout? Seems like it would just spin. I think the throwout was installed incorrectly by whoever did it last, so i'm not sure how it's supposed to go. Could anyone help me out? maybe some pics?

[M3NTAL]

[URL=http://s34.photobucket.com/user/BLACKNBLOWN/media/950053F4-B505-43D6-AAA8-E0EE65818D34_zpswi0dfv79.jpg.html][/URL

[Diesel_River]

Thank you very much. Do you happen to have the torque specs for the 4 bolts holding the bell housing to the engine? Any other torque specs i might need? I just ordered a haynes, i looked everywhere for one in stores and had no luck