Tweet
Any ideas besides padnos? 
Sent from my 2PS64 using Tapatalk
Sent from my 2PS64 using Tapatalk
-
-
Cut the whole core support out and replace it with 2"x3" angle iron.
And move away from the rest belt!~Nate
the keeper of a wonderful lil car, Skeeter.
Current cars:
91L "Skeeter" 170k, Aspire brakes, G15, BP, Advancedynamics coil overs, etc. My first love.
1990 Kawasaki Ninja 250 - my gas saver, 60+mpg - 40k
2004 MotoGuzzi Breva - my "longer range" bike - 17k
FOTY 2008 winner! -
If you had a festive sway bar on there it would hold it up lol.
But yes 3x2 angle 2x2 works fine as well and is more common I've used both without issue. I've used 1/4 inch thick but thinner would also work.Comment
-
There were photos of this fix on the site. You might try searching.Original owner of silver grey carburetted 1989 Festiva. 105k km as of June 2006. 140k km as of June 2021.Comment
-
Tapatalk is garbage for searching.
I'll wrap it with some angle.
Yes. Rust belt is a bad area.
Sent from my 2PS64 using TapatalkComment
Comment