Procces pictures...

[MEXTIVA]

I had a valve go bad on my b6t over 3 months ago I was busy and lazy...Finally got off my las ... and started working on replacing the whole engine since I had one spare.
I should fire it up tomorrow if I have the time.Wish me luck!!!

[B6T]

That's a clean looking car... I've never seen a Festiva without any form of rust on it.

Nice exhaust cut out too!

[25Horseplay]

I hope it run's as good or better than the old engine!

[MEXTIVA]

Thank's,

Yeah the car has minor rust on parts that can be replaced so im not worried about them for now.This is the reason I started with this shell,There are lots of no rust cars here but most of them are beat up.


Hopefully it will run nice,I was amazed on how clean the engine is on the inside.There is no residues from coolant,The thermostad was as clean as new.timing belt looks new,turbo look's new too.I hope someone bought an engine and did'nt used it much..If not new this engine has really low miles.If it starts I have to say that I scored big time.Got the complete pull out for $350,minus axles or wiring but everything else.

[Hot_Wheels]

can we see pics of you rear trans mount and crossmember well its out?? it might help some people when making mounts.

Thanks

[MEXTIVA]

The engine is back in the car before posting this pictures.I just bought another festiva and might make some mounts for it.
I have mentioned before, With my set of mounts you have to modify the passenger side axle so I'm not sure you want to
go this route unless your willing to work more on the swap.I'm working on replacing a boot on that axle and believe me its
a pain.Since is welded @ some point.

But if you are willing to go this route I'll post some pictures later on....

[packrat427]

WOW , Mextiva is swimming in B6T's .

Remember to post pics often of the progress on all the projects

[MEXTIVA]

WOW , Mextiva is swimming in B6T's .

Remember to post pics often of the progress on all the projects

I have 3 B6T and two festiva's as of yesterday.I don't know if i'm going to start my next swap with this shell though.I will check it out today and decide.I will do another one thats for sure.....Soon!!!