Chris's B6T Swap Pg 26

This first shot is of the exhaust I built. This exhaust is 2 1/2inch dia mandrel bent and all stainless except for the flanges and hangers, which I have painted with primer to keep the rust off until I can run the car and cure the hi-temp paint I got for these pieces. The cat is a Hi-flow unit from Road/Race engineering.

This is a a lengthwise shot of the exhaust, note how much straighter it is then stock, with only two 90deg turns and two 35deg turns to go over the rear suspension, then out though a canister muffler. This muffler has a removable silencer to cut down the sound a bit if you want. I attached the final muffler with a stainless steel band clamp from Burns stainless.

this is a shot of the entire exhaust

Author: Chris Rummel

Chris's B6T Swap Pg 25 - Chris's B6T Swap Pg 27

(Except Text and images courtesy of Chris Rummel)