B6d exhaust manifolds

[bhearts]

Bought a couple flanges last week, going to make a couple log t3 manifolds then I might upgrade my skills to something like a ram horn for the 1.6. That design is slightly more complex than a log :-). I made my weld fixture today as to minimize flange warping. uploadfromtaptalk1447550823874.jpguploadfromtaptalk1447550839901.jpg

Sent from my SM-G900V using Tapatalk

[MiltonHavoc]

Ooh. You have my attention

[bhearts]

Ordered tees and els today in schedule 10 304 stainless. Hope to have progress pics by this weekend.

Sent from my SM-G900V using Tapatalk

[fastivaca]

Subscribed!!!

[bhearts]

uploadfromtaptalk1447893662749.jpg pretty cool looking cnc tapered flanges. Here's the front and the back.

Sent from my SM-G900V using Tapatalk

[william]

Those look cool I have a megan racing top mount converted to down mount and t3. I was gunna cut the head flange off and make a long tube for the b6d.
Are there any cheap headers out there with similar port spacig?

[bhearts]

No fwd b6d headers available. Maybe Honda. But too much work

Sent from my SM-G900V using Tapatalk

[bhearts]

needs some pipe trimming. Nice parts though.

Sent from my SM-G900V using Tapatalk

[ZephTheChef]

Man, we need a cold cut saw so bad.

[bhearts]

t3 flange. Pipes cut. Ready to weld.

Sent from my SM-G900V using Tapatalk

[Meepersly]

that looks amazing I would love to see what it looks like after the weld.

[bhearts]

Opinions or expertise on what angle the turbo flange should be, or if it should be centered or off center one way or the other.

Sent from my SM-G900V using Tapatalk

[bhearts]

that looks amazing I would love to see what it looks like after the weld.

Thanks. Need to get a split port gas regulator so I can back flush this thing with argon for welding. Don't want any sugaring on the inside. Sucks I can't just do this overnight. I get a step further and I'm off to mctool for one thing or another. Bought a good miter saw today. Better than the typical chop saw because of angle adjustments.

Sent from my SM-G900V using Tapatalk

[ZephTheChef]

Thanks. Need to get a split port gas regulator so I can back flush this thing with argon for welding. Don't want any sugaring on the inside. Sucks I can't just do this overnight. I get a step further and I'm off to mctool for one thing or another. Bought a good miter saw today. Better than the typical chop saw because of angle adjustments.

Sent from my SM-G900V using Tapatalk

I think I have some solar flux still laying around somewhere. I'd hate to see what a dual flowmeter would cost at airgas. Unless you wanna order one online.

[bhearts]

I think I have some solar flux still laying around somewhere. I'd hate to see what a dual flowmeter would cost at airgas. Unless you wanna order one online.

I suspect we could tee it with a restrictor, right?

Sent from my SM-G900V using Tapatalk