cut and roll those guards.

[pumbaplus]

Hi all, got my new festy, a 93 with aircon and 115k KM , awesome.

Anyways,
i noticed 2 festys with either cut or rolled guards like in this pic.

howd they do this? is there a way to do this so i don't have to respray? i heard some roling with a heat gun and the paint will be ok, but the pic looks pretty extreme. i want to do about an inch less than the pic. i want some 15s and to lower the thing...
the B6t is ready and waiting in the garage.... .

[Damkid]

i beleive that festiva is from the phillipines there was a link about it a while back i'll see if i can find it

[Damkid]

here's the thread talking about it

http://www.fordfestiva.com/forums/showthread.php?t=12839&highlight=camber+plates

and here's his cardomain site

http://www.cardomain.com/ride/2810021

[25Horseplay]

That car was highly modyfied. It was a 4 door made into a 2 door!

[Pocket_Rocket]

Yep, and if I remember correctly, he's rolling on 15's with 205/50-15 tires, which he had to cut the fenders, modify the fenderwells, and runs on ultra stiff, short-travel modified JIC Magic coilovers. But it is possible to run 15s without cutting the fenders if you have the right tire/width/offset, just check out Cam's ex-car...

[pumbaplus]

i dont want to cut the guards , but it looks cool..... i know it's hard but if i can do it i will.

i've seen specs on that car but think the cut on it is 2 extreme, i'm only wanting 2 inches....