under $10.00 mod

[hytekredneck]

went to the junkyard looking for a mazda truck with clear turns but all had amber. I looked over and seen a Toyota Camery early 90's with clears and took the lens and the enitre unit off the car because they looked about the same size. Well if the didn't fit I would only be out a couple bucks.

[hytekredneck]

I went on and used the toyota turn signal assembly just cut my wires and rewired it up. Stopped at Lowes and picked up some nylon bushings 1/2inch to make them flush with the bumper and 2inch stainless screws to remount it. I could have put a thin bead of silicone around the lens and used the festiva turn signal assembly if I wanted but just went on and wired the toyota up. The holes actually line up.

[hytekredneck]

here's more

[FB71]

yup, that's been done before. But it's always good to bring these mods up again for the new folks.

[CHills]

Nicely done, it looks good!

[Festiva_tunner]

I like the use of the nylon spacer instead of stacking washers

[goblazers_6]

i used an aluminium spacer on mine i got at the local hardware store

[hytekredneck]

Thanks guys, I figured nylon bushings = NO RUST:p