110 mph speedo/tach

[jimjimz]

I purchased it from overseas and found out its not plug and play -it didnt wire up the same. Ive been at it with a test light and havent quiet figured it all out. HELP im getting fffrustrated! ok im calm now is there anyone who can help me out with what wire goes to what pin - a diagram or something :study:

[ejp2fast]

Check out this thread in the articles section. That may help.

[hotfordcat]

^^^ What he said. I have two I got in England out of Kia Prides. Easy fix!!

Chuck

[jimjimz]

uhg pics on link were deleted from photobucket... But thanks for pointing me in the right direction now i just have to get a festy speedo/tach

[25Horseplay]

You can use the circuit board off a US tach cluster and it will plug right in.

[hotfordcat]

You can use the circuit board off a US tach cluster and it will plug right in.

There are however a couple of small modifications you will have to make.
1. There are two resistors on the back of the Euro board that are larger than the US. I had to use a dremel and open the holes for them alittle.
2. The speedo cable will have to be moved to the right of the speedo around a brace in the dash, as you look at it from the drivers seat.

Now mount the US circuit board and it's plug and play.

Chuck

[25Horseplay]

I didn't have to open up anything on mine. Wonder if theres a small diffeance in years? And yes the speedo cable will have to be rerouted as in any tach dash install. (thanks for reminding me, I always forget that!)

[hotfordcat]

I didn't have to open up anything on mine. Wonder if theres a small diffeance in years? And yes the speedo cable will have to be rerouted as in any tach dash install. (thanks for reminding me, I always forget that!)

Could be Brian, I didn't asked Greg at the Breakers what year they were, I was only glad he had two, and shipped them to me. Will need one now for sure. Finally got the B6 in the 91L this week-end. Ran GREAT till the old fuel pump died. LOL
Chuck

[Damkid]

I didn't have to open up anything on mine. Wonder if theres a small diffeance in years? And yes the speedo cable will have to be rerouted as in any tach dash install. (thanks for reminding me, I always forget that!)

when i swapped circuit boards on my 180 km'h tach cluster i had to trim it a bit as well

[muscle_Car1]

I think we had this discusstion before. Like when I put mine in.

[Festiva_tunner]

uhg pics on link were deleted from photobucket... But thanks for pointing me in the right direction now i just have to get a festy speedo/tach

PM me your email I have it on hard copy

[festy90]

where would i go about finding a speedo that reads over 85mph that will fit in my car

[Festiva_tunner]

where would i go about finding a speedo that reads over 85mph that will fit in my car

you can get the overseas one that goes to 110 or you can mod in a protege spedo that goes to 140, you will have to make a new faceplate for the protege spedo.

[gorgonheimer]

protege all the way. tell me how and i will do it. i have one sitting in my yard right now