Replacement Bolt Kits

[Festiva_tunner]

I'm putting together Bolt Kits for our suspension components - After searching for the replacement bolts (or lack there of) through parts stores I have resulted to using Fastenal - I have sourced all the required bolts accept for the bolts that hold the rear beam on.

If someone can get me some measurements of these bolts it would be greatly appreciated.


I've circled the bolts I still need confirmation on. They are the Strut attaching bolts, The Torsion beam bracket bolts and the torsion beam pivot bolts. These are all for the rear - I have confirmation on the front.



I need the measurements like the following below - the Bolt shown is the front strut to hub mounting bolts (M12x55 with thread pitch of 1.5)
Also I need to know if the nut is flanged and if it is a suraded locking nut attached is not.

[perucho]

I have a set of those bolts in my garage. I can send you the measurements later today.

[Hot_Wheels]

the shock bolt i was able to find a dead match at carguest, it wasn't threaded all the way either, it was 100% the same

[Festiva_tunner]

the shock bolt i was able to find a dead match at carguest, it wasn't threaded all the way either, it was 100% the same

Any chance you still have the PN? also how much was that bolt?

What I'm trying to do is buy these in bulk so save some money and sell the whole suspension kit on the forum for cheaper than you could source all of the bolt kits from the several differnet stores

[eurotiva]

^ thank you

[JPT]

^ thank you

x2!

[Hot_Wheels]

when i get some cash ill head over there any buy another and get the pn

[perucho]

Torsion beam bracket bolts:
One (1) M12x35-1.25
Two (2) M10x30-1.25

Strut attaching bolt:
One (1) M10x70-1.25

Torsion beam pivot bolt:
???

Notes: The M12 is 35 mm long but could be 30mm long. The number of bolts shown will do one side. Don't have a torsion beam pivot bolt laying around

Hope this helps.

[Festiva_tunner]

Torsion beam bracket bolts:
One (1) M12x35-1.25
Two (2) M10x30-1.25

Strut attaching bolt:
One (1) M10x70-1.25

Torsion beam pivot bolt:
???

Notes: The M12 is 35 mm long but could be 30mm long. The number of bolts shown will do one side. Don't have a torsion beam pivot bolt laying around

Oscar this is awesome - anyone assist with the pivot bolt?