Tweet
At higher speeds I notice a tic tic tic tic in the front end low, let off and it quits. Is this a Cv going bad or in need of lube? Help don't like this, can feel it.
-
-
High probability of CV, and more likely outer CV than inner.
Noise is present under acceleration but not at steady cruise.
Noise should also be present and maybe worse in turns.
Even if the boot is intact, it is likely easier and more efficient just to swap the entire axle for a new/rebuilt unit.'93 Blue 5spd 230K(down for clutch and overall maintanence)
'93 White B6 swap thanks to Skeeters Keeper
'92 Aqua parts Car
'93 Turquoise 5spd 137K
'90 White LX Thanks to FB71
"Your God of repentance will not save you.
Your holy ghost will not save you.
Your God plutonium will not save you.
In fact...
...You will not be saved!"
Prince of Darkness -1987
-
see some wear on bushing on control arm could that cause it, don't think it cv's had been changed, look new, right side shakes and stops if you let off, get back into it may be fine or may start shake and tic tic tic noise. In turns not making any noise. I had changed cv's on a mazda already, not they same. Ball joint? thanks scottComment
Comment