Who has the lowest?

[falkenfighter]

Whos slammed? Pics please and info on setup and any problems you ran into such as clearance, alignment, so on and so forth.

[bhearts]

http://www.fordfestiva.com/forums/showthread.php?t=29547

[bhazard]

Haha.... That build was BEYOND ghetto. Getting ready to scrap that body now.

[william]

Agreed, But it Looked good that low.
I think with the right wheel and tire combo you could get pretty low.

[bhearts]

Haha.... That build was BEYOND ghetto. Getting ready to scrap that body now.

I thought it was awesome. Was it just because the chassis was trashed?

[bhazard]

They totally ghetto'd it. Springs were cut down to nothing. They ran those steel cable locks used for locking up semi trailers through the spring and into the body to hold them in place. They cut out a huge piece of the inner fender in front of the strut tower and riveted in sheet metal for tire clearance. All on a car that had no floors and chunks of frame rail rotted away. The rear beam mounts are compromised too.

[shorestiva]

http://www.fordfestiva.com/forums/showthread.php?t=46451

I wouldn't recommend going any lower without flipping the tie rods. They were really close to hitting the body.

[falkenfighter]

By flipping tie rods do you mean cutting the knuckles and flipping that over so the taper is the correct way?

[shorestiva]

I was thinking more like something like this just need to get a insert machined with the correct taper.

http://store.blackforestindustries.com/tierodfkimk.html

[deathrace2000]

*rolls eyes*

[FastOrBust]

What size tires are on there deathrace?

[micro_trucktiva]

Cut springs, I think a coil and a half were taken out. I didn't do it so I'm not entirely sure, I bought it this way