front control arm tie bar fabrication.

[Hot_Wheels]

So I bought the eBay tie bar from the the Philippines but it's not very strong and almost made out of tin. I'm sure it's better the nothing but I sought out to make a stronger tie bar. I made the cups last night now I'm tacking the angle drop arms. I didn't realize but cups/flange appear to angle inward and are not flat. So I'm following the angles of the eBay bar. I'm guessing they wont go straight if that makes sense? I need to figure out at what angle and how to miter cut the drop bars so that I can join it to the main support bar if that makes sense? Any input is greatly appreciated.

[bhazard]

Where does this actually bolt on?

[Hot_Wheels]

This is the eBay one I mod to fit. My Trans was a lot lower and we extended one side. But I'm going to redo the entire bar as you see now.

[bhazard]

I just don't see how this helps anything. At first I thought maybe some sort of traction bar, something to keep the control arms from moving back or forth.

[bhazard]

But oh wow looks like you already figured that out lol

[Hot_Wheels]

[Festiver]

That's really neat actually I like it Im gonna try to make one after the bp g swap is done

Sent from my XT1585 using Tapatalk