minigun rear view

[91_festy_Gl]

It looks like a dulley from the rear.

[resuwrecked]

I would say notch the bumper and have the bottom of the pipes flush with the bottom of the bumper but since you have other exhaust piping already visible I think it wouldnt look bad if you just put a little notch in the bumper and had only 25% of the tip recessed into the bumper.

kind of like this

http://image.automotive.com/f/techarticles/engine/mdmp_0909_2005_mustang_bassani_dual_exhaust_system_install_upgrade/24499180+pheader/mdmp_0909_01_z+2005_mustang_bassani_dual_exhaust_system_install_upgrade+front_view.jpg

I dunno...

[Festiva Time]

I always like them to come out and rake up [45 degrees?] Not too long though. Make sure it doesn't stick too far put that you slice your leg on it. I keep forgeting about my trailer hitch and whack my leg (on it) when I go to open the hatch.

-Kirk

[NovaSS]

doing final stuff to rear bumper, its saggin a little because its just hanging, not bolted to mounts.

Im going to use square exhausts tips , should I have them haning below the bumper or notch the bottom lip and have them sitting higher ? I think they would look better in a notched bumper.

NOTE, the black cable is part of the clutch, it will be tucked up, the other two pipe are part of the exhaust, not much I can do about them , ran out of room

I have noticed that the tail lights will be block when viewed from certain angles from the side. I may install small marker lights in the rear fender flares behind the tires.