Announcement

Collapse
No announcement yet.

no spark on bp swap

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • no spark on bp swap

    Hey guys I don't have any spark on my bp swap . I have 12v power at the coil distributor and module , I've tested the coil and it seems good . What is a good way to test the distributor? On my swap the motor is rebuilt so it has new belt cap rotor wires plugs , just to let you guys know. any help would be great thanks Ask me some questions if you need more info on my swap

  • #2
    Originally posted by dragsterdave View Post
    I've tested the coil and it seems good.
    Do you have power from the coil to the dist?

    BPT, G5M-R, BP26 Exintake swap + Fidanza cam gear, NSRT4 FMIC + 2.5" piping, HKS SSQV BOV, Exedy clutch, 3" downpipe + 2" all the way back, Aspire brake swap, KYB GR-2 & FMS coil spring , FMS EURO body kit + Carbon fiber hood, Falcon RTX 15X6½ + Toyo proxes T1R 195/45R15

    Comment


    • #3
      No I don't , if I am reading the book right I should have power from the coil black wire 12v going in the coil and coming out at the yellow/blue wire. From there it goes to the rpm test wire , ign module and to the distributor. I only have power at the coil,module and rpm test wire. Am I right so far?


      As for my distributor plug I have the
      festiva black going to the black/ light blue on the bp

      festiva yellow/black going to the white/red on the bp 12v run

      festiva yellow/blue going to the white on the bp

      and the 4th wire yellow/blue or green to the ecu

      Comment


      • #4
        I think I'm wrong about the yellow/blue from the coil, I don't think it goes to the distributor. I think the white wire from the distributor goes to the ecm. The ecm sees that signal and grounds it out witch make the injectors fire , the yellow/blue wire from the distributor sends a signal to the ecm . The ecm tell the module to ground the coil and send a spark to the distributor. I'm I right but this or am I reading the manual wrong? any help would be great

        Comment


        • #5
          Think I found the problem I had three broken wires at the ecm. If all goes well first start up tomorrow morning

          Comment


          • #6
            Keep us updated! Good luck!
            -------------------------------------------------------------------------------------------
            Nancy- 1.8L BP, aspire swap, g-trans
            The Adventures of Nancy! Build Thread
            -------------------------------------------------------------------------------------------

            My Musica! Click me!

            Comment


            • #7
              I will she runs but I still have a list to check off. I did the aspire brake swap but I bought a bad driver side hub. I have a axle seal leaking, needs full exhaust, engine light on , no horn, alinement , and I don't have any low end . I did the exhaust cam swap so I need to play with my adjustable cam gears. Its been along time to get to this point , but it seems like a fun car.

              Comment

              Working...
              X