Tweet
Anyone have a picture of the 1.6 Capri motor & the intake manifold?
Ken
Ken
-
"The man who can kneel before GOD,
can stand before any man." -
i do and i'll load it in just a minuteOriginally posted by 4efte-tercel View Post
1988 323 Station Wagon - KLG4 swapped
1988 323 GT - B6T Powered
2008 Ford Escape - Rollover Survivor
1990 Festiva - First Ever Completed KLZE swap (SOLD)
If no one from the future stops you from doing it, how bad of a decision can it really be?Comment
-
1988 323 Station Wagon - KLG4 swapped
1988 323 GT - B6T Powered
2008 Ford Escape - Rollover Survivor
1990 Festiva - First Ever Completed KLZE swap (SOLD)
If no one from the future stops you from doing it, how bad of a decision can it really be?Comment
-
the b6t manifold prob wont bolt up because the mx3 motor is just like the 1.6 miata. the bolts line up but i know some of the coolant passages are different. i put a miata manifold on a b6t and had to ad a coolant nipple for the heater core. not sure if it would be worth it i would just use a hammer.. the mx3 one probably flows better..
i just looked again and they did use a hammer. i have a few b6t manifolds if you want to try pm me.Last edited by ketchup; 09-26-2008, 09:18 PM.YOU WILL HEINZ 57!!!!Comment
-
So.....
there is not an intake manifold (shorter one) that will bolt up
to the motor in the first post's picture without water passage
problems/concerns correct?
Ken"The man who can kneel before GOD,
can stand before any man."Comment
Comment