Tweet
How do I tell if my injectors are pulsing? Did the B6T swap and am not sure if I have spark or fuel. I know how to check spark.
-
you can get to the injector, disconnect the harness and check the resistance...
actually i'd try this first: try to start it, then take out one or all spark plugs and use a flashlight to see if the piston top is wet... if yes, likely injectors are working, if no, they are not.
once started, to make sure all the injectors are working, take a long screwdriver (or engine stethoscope) and listen for the ticking of each injector solenoid.
-"Hairlipstiva" 1991 GL 5spd (swapped from an auto), rolling on Enkei 14x6 +38 with 195/45/14 Toyo's, Jensen MP5720 CD deck, tach install, LED strip in cluster, down position rear wiper, FMS springs, Gabriel shocks on 4 corners, Acura Integra short shifter
-Escort GT 91 donor car with BP, G5M-R tranny to be dropped in the little guy...
-Aspire brake swap COMPLETE!
https://www.wunderground.com/persona...?ID=KOKOWASS38
Comment