Installing engine & trans...what to replace

[chadzeilenga]

Timing Idler Torque?

And hopefully last: What's the timing idler torque?

does anyone have a diagram for assembling the main crank bolt & pulley onto engine? I think I have a large washer left over that I think went to the main crank, but it won't fit on with the 4-bolt bracket installed?

[chadzeilenga]

I checked and the Intake & exhaust bolts are both M8 thread

[GenevaDirt]

And hopefully last: What's the timing idler torque?

does anyone have a diagram for assembling the main crank bolt & pulley onto engine? I think I have a large washer left over that I think went to the main crank, but it won't fit on with the 4-bolt bracket installed?

I did not torque mine. Once the belt is on....just let the idler go and whatever pressure it puts on the belt is good. Tighten the bolt pretty good.
Those big washers are fun trying to remember where they go. The big beveled thin one first....then the smaller thin one...then the pulley (pulleys if you have air) then the thicker ones...then the one that has an egg shaped hole in the center.