head games

[NovaSS]

Some may remember I blew out the coolant by pass line last week and ran it hot.

Pulled the head today, the block look good and measured out fine ( flat bar/ feeler gauge). The head was another story, I could get a .023 feelr gauge under the straight endge in the center.
To be honest the top of the pistons were nice and clean, good old steam cleaning as it wrapped I guess

[ejp2fast]

wow, 23 thou.... new head time!! don't forget to port and polish!

[NovaSS]

Thanks to ebay and the internet I picked up a new head.... yes NEW as in never installed head , a "new old stock" cam, new valves and springs too.

As for port / polish.... naaaa i need to spend the time on minigun.

[ejp2fast]

Thanks to ebay and the internet I picked up a new head.... yes NEW as in never installed head , a "new old stock" cam, new valves and springs too.

As for port / polish.... naaaa i need to spend the time on minigun.

i guess minigun would be a little higher on that priority list.........

[Kraig]

How's your back doing?

[FB71]

Thanks to ebay and the internet I picked up a new head.... yes NEW as in never installed head , a "new old stock" cam, new valves and springs too.

As for port / polish.... naaaa i need to spend the time on minigun.

ha! yeah, Pu241's head was warped 0.021-0.022.

[leapin]

Now I have foreigner stuck in my head.

[Damkid]

ha! yeah, Pu241's head was warped 0.021-0.022.

Ya his head sure is pretty warped :lol: :lol: J/K

[MONSOON]

Pfft, why J/K? Its true!

[NovaSS]

How's your back doing?

would be doin better if I was humped over this festiva.

[Pu241]

^^^ I resemble all of those remarks!