Announcement

Collapse
No announcement yet.

Help transmission!!!!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Help transmission!!!!

    I have my manual tranny from my ford aspire laying on a table all in one piece now, I just replaced the input shaft bearing and then i tried to putting it into gear by hand and it will not budge???? What do I do?? the shaft spins so do the axles...Im freaking out and dont know what else to do! This is my first time i messed with a tranny.

  • #2
    You must have one of the shift shafts in a bind. They are very hard to get into gear on the bench.
    -Greg
    Euro-bprt...WORLDS FASTEST FESTIVA !!! 11.78@115.9
    BP, G trans, Megasquirt/ 550cc inj. t3/t3 (tbird) Garrett, REAR TURBO!!!! AND AC!!!!
    Redneck Engineer
    FOTY - '09
    5x Festiva Madness Attendee...FM 3,4,5,6,8
    http://www.youtube.com/watch?v=LpCZ7...9Pwqw-oe8s2OYQ
    http://www.youtube.com/watch?v=vU_eX...9Pwqw-oe8s2OYQ

    Comment


    • #3
      I have rebuilt a few of these transmissions and what I believe is the issue is that you have the internal forks out of position. Unfortunately, you will hae to split the case open again to correct it.

      Comment

      Working...
      X