Shifter Bushings - What size bolt?

[hckrphil]

So I've read that you can only replace 4 out of the 6 shifter bushings.

The remaining 2 you have to grind off a piece and replace it with a bolt.

My question is, what size bolt should I buy to replace the ground off piece?

I already ordered the 6 bushings thru NAPA, just need to pick up the bolt now.

Thanks everyone!
~Phil

[Nerd Racing]

M10 I'm guessing since the bushings are 10mm ID.

[hckrphil]

I'll just take the bushing with me and get a bolt that fits thru it easily.... what about length? How long should it be?

[Rocketman]

Which bushing do you have to grind?

[hckrphil]

Shouldn't have to grind the bushings, but more of grinding the pin that goes thru 2 of the existing bushings to remove them. Then replace the ground off pin with a new bolt....

I just haven't gotten under the car to physically measure....... was hoping someone would know the size.

Phil

[denguy]

http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=170542738839

Here is a picture of the "shoulder" bolt you need. The shoulder is 1 7/8" long and has a 3/8" diameter. 1 mm = .040", 10 mm = .400",
3/8" = .375"