Tweet
Thanks for all the input! Never really did figure out what the problem was but i solved it by installing Aspire brakes etc. Front done, just have to return to PnP to get the back half.
-
Ian
Calgary AB, Canada
93 L B6T: June 2016 FOTM
59 Austin Healey "Bugeye" Sprite
"It's infinitely better to fail with courage than to sit idle with fear...." Chip Gaines (pg 167 of Capital Gaines, Smart Things I Learned Doing Stupid Stuff)
Link to the "Road Trip Starting Points" page of my Econobox Café blog -
I would bet your problem is caster due to taking the lower control arm loose. Caster differences can make a car pull without trying to go into a turn. My caster is off right now from replacing my lower control arms I have a new steering rack , shocks , front bearings and a rear main seal in the mail though. Trying to finish all the work I want done before I leave the shop this week to start a state job so holding off on doing my alignment. Those swaybar nuts are going to be your culprit I suspect.Comment
Comment