Help with Front end Shaking and noise, What could be wrong?

[FestYboy]

did you check you're lugnuts? and it depends if the pins are striking the wheel hard enough (could cause a wobble sensation by causing the wheel to slow down enough when striking the caliper pins.)

[crazyrog17]

I vote brake pins will solve the sound issue, but it's a safety issue too. The dang things hold your brake pads in place! Total; sub $10, sub 20 minute DIY job.

[Chilenoloco88]

I vote brake pins will solve the sound issue, but it's a safety issue too. The dang things hold your brake pads in place! Total; sub $10, sub 20 minute DIY job.

I Bought the Brake pins and fixing them as soon as possible, about the wobble i will let everyone know when i find out.

[Chobobulous]

Slightly off topic. Do you drive a teal GL chilenoloco88

[denguy]

I have the same problem with my stock 92. If you solve this issue please post the answer.

[lessersivad]

Couldn't the front and rear tire/wheel combos be swapped to the rear, and the rears to the front to see if the wobble/shake goes away or possibly move to the rear?

[nitrofarm]

Sorry for the wind noise but you can still hear it

http://www.youtube.com/watch?v=f6NtHCrVZkw

That sounds like a space shuttle launch imo

[nitrofarm]

That sounds like a space shuttle launch imo

Make sure the caliper can "Float" on the mounting bushings. This is a common place for these breaks to seize with corrosion. Then your caliper gets cocked,breaks heat up and all Hell starts to break loose.And it always seems like its the longer bushing that sticks first om mine.

[beuford65]

I have the same or similar problem. Happens when I brake. But not every time.

[RhodeStiva]

^x2 or maybe make sure you tightened the new tie rod end nuts good -n- tight.
or the shocks are bad.

[denguy]

The rubber hose to the caliper can get plugged up with corrosion. Happened to me.