Announcement

Collapse
No announcement yet.

Take off Vibration

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Take off Vibration

    When I let the clutch out I get some wobbly vibration just wondering if you guys have any insight on this bad clutch or half shift maybe it comes from the drivers side .. and I know how to drive a stick lol

  • #2
    I was getting clutch chatter, mostly in damp weather, but it went away. Read at the time that it could be moisture or could be dirt or glazing build up on the clutch. Could be other things, like worn out clutch on a higher milage vehicle. No wobblies in my case, just usual clutch chatter vibration.
    Original owner of silver grey carburetted 1989 Festiva. 105k km as of June 2006. 140k km as of June 2021.

    Comment


    • #3
      Motor mounts?
      "Its not fast, but its fast for a festiva."

      Comment


      • #4
        Check lower control arms. Aka ball joints
        -Greg
        Euro-bprt...WORLDS FASTEST FESTIVA !!! 11.78@115.9
        BP, G trans, Megasquirt/ 550cc inj. t3/t3 (tbird) Garrett, REAR TURBO!!!! AND AC!!!!
        Redneck Engineer
        FOTY - '09
        5x Festiva Madness Attendee...FM 3,4,5,6,8
        http://www.youtube.com/watch?v=LpCZ7...9Pwqw-oe8s2OYQ
        http://www.youtube.com/watch?v=vU_eX...9Pwqw-oe8s2OYQ

        Comment


        • #5
          I've been investigating front end noise. Mechanic noticed separated rear motor mount and said it would cause noise when starting or stopping. To check, lift front end of car and insert pry bar into motor mount through hole in cross member engine support. He was able to show me separation in mount by pulling down on pry bar.
          Original owner of silver grey carburetted 1989 Festiva. 105k km as of June 2006. 140k km as of June 2021.

          Comment


          • #6
            Thats what motor mounts do. They vibrate. I always assumed my aspire vibrates from a start due to the insane amount of torque it takes to get a car rolling, and the little torque the engine offers at low rpms

            Sent from my SGH-T989 using Tapatalk

            Comment


            • #7
              When I rev to 2k and ease off the clutch pedal the shaking goes away. But trying to do the same at engine idle doesn't work well

              Sent from my SGH-T989 using Tapatalk

              Comment


              • #8
                Alright ya ill check that stuff out noticed a little clicking so cv axel is going .. I'll probably change that in a few weeks and check every thing out under there thanks for the input guys

                Comment

                Working...
                X