Turn Signals/Hazards not working

[patrickg0022]

So I replaced my cv axles and seals with a buddy and somehow along the way the "MAIN" fusible link wire got broken. I replaced all with the cartridge style fuses. I had no problems with the turn signals prior to the old fusible link breaking. They worked fine for about a week and then I noticed my turn signals wouldn't work sometimes. I figured out if I just wiggled the "MAIN" cartridge fuse, they would work and I would drive a few miles and I guess the vibrations made it work itself back out. Last night I took apart the fusible link box and cleaned all the corrosion off of the wires. It didn't make a difference at all. When I engage the turn signal you can hear the relay click once. Same thing for the hazards. So I am assuming it is still working? If anyone has any advice or tips, they would be much appreciated.

[muleskinner]

Check the fuse in the car in the fuse box marked "hazard". Maybe it's that simple.

[crazyrog17]

Check for bad grounds too.. like everywhere on the 20+ yo vehicle. Have to remember circuits are +12V positive and -12V ground.

Have we considered the flasher module might be bad? It's a bi-metal thermal switch that wears out over time

[patrickg0022]

The fuses were the first thing I checked. They are all good. Also checked a few grounds and they seemed fine. Ill check some more next. Is the flasher module the box that clicks under the dash? I thought that was just a relay.